What I want to achieve: the fastest, low latency, unprocessed, pass-through possible of 2 SFP ports.
I'm using a 2.5GB SFP ONU in sfp-port1, and my router/firewall connected to sfp-port2 via SFP 10GB.
My router/firewall is handling everything, but doesn't support 2.5GB SFP.
The only task the Mikrotik should do is passing through traffic between 2 SFP ports with different speed (2.5/10).
This is my current config - are there any improvements I can make?
Code: Select all
name="bridge" mtu=auto actual-mtu=1500 l2mtu=1592 arp=enabled arp-timeout=auto mac-address=XX:XX:XX:XX:XX:XX protocol-mode=none fast-forward=yes igmp-snooping=no auto-mac=no
admin-mac=XX:XX:XX:XX:XX:XX ageing-time=5m vlan-filtering=no dhcp-snooping=no port-cost-mode=long
name="sfp-sfpplus1" default-name="sfp-sfpplus1" mtu=1500 l2mtu=1592 mac-address=XX:XX:XX:XX:XX:XX orig-mac-address=XX:XX:XX:XX:XX:XX arp=enabled arp-timeout=auto loop-protect=off
loop-protect-status=off loop-protect-send-interval=5s loop-protect-disable-time=5m auto-negotiation=no tx-flow-control=on rx-flow-control=on speed=10G-baseCR bandwidth=unlimited/unlimited
switch=switch1 sfp-rate-select=high sfp-shutdown-temperature=95C
name="sfp-sfpplus2" default-name="sfp-sfpplus2" mtu=1500 l2mtu=1592 mac-address=XX:XX:XX:XX:XX:XX orig-mac-address=XX:XX:XX:XX:XX:XX arp=enabled arp-timeout=auto loop-protect=off
loop-protect-status=off loop-protect-send-interval=5s loop-protect-disable-time=5m auto-negotiation=no tx-flow-control=on rx-flow-control=on speed=2.5G-baseX bandwidth=unlimited/unlimited
switch=switch1 sfp-rate-select=high sfp-shutdown-temperature=95C
name="switch1" type=Marvell-98DX3236 mirror-source=none mirror-target=none l3-hw-offloading=yes qos-hw-offloading=no