Hi all,
Trying to Netinstall 7.12 to my hAP ax2, it says installing then Ready after I try to flash 7.12 to it via netinstall but after reboot it still has 7.12RC6.
Do I need to do anything special, might be missing a step somewhere this is what I did.
I've reset to Default first.
RouterBoard settings....
Boot Device: nand-if-fail-then-ethernet
Boot Protocol: Bootp
Everthing else is unticked in the Routerboard settings section
What I did was extract all the files to my Desktop
set 192.168.88.2 PC
set 192.168.88.1/24 Gateway
Run netinstall 7.12 as Administrator
set 192.168.88.3 Net Booting Tab
selected default config switch and highlight the files I want to install...
RouterOS-7.12-arm64.npk
Wifiwave2-7.12-arm64.npk
Clicked on the device I want to flash in the upper section then pressed install.