Hi,
Just an FYI for anyone using the Brave browser on Windows with sync enabled, if you browse to the switch IP it will take you straight to the System tab without requesting credentials.
Browser is set to never save passwords, and passwords are not enabled as part of the sync process.
I've just purchased a CSS106-1G-4P-1S and a CSS106-5G-1S switch.
All I've done so far is upgrade from SwOS 2.11 to 2.13, set a static IP for each switch via DCHP, and specify the same IP as the fallback address, and set a password.
I can logout, which gives me a login page, and I can login with my new password.
However, if I log out, then close Brave, reopen it, and browse to the switch IP it bypasses the login request entirely.
This is true for both switches.
Logging onto another device which has never accessed the switch IPs before, but also uses Brave sync, allows direct access to the switches.
Chrome and Edge both always request a password.
I haven't tried Brave on Linux yet, but I suspect it will exhibit the same behaviour.