Hi, after upgrading my beloved CRS305 from 7.13.3 to 7.14 I can´t connect to it any more.
There were no additional packages on the switch and the config was also quite simple (just a few VLANS & basic management access)
-When powering on, the sequence is:
-The power led is on, then all interface leds light up for a second.
-After a long wait, maybe a minute or so, the 1G Cu port starts working, L1 link gets established, but I can´t connect via winbox.
-The port stays up for a while, then all 4 SFP LEDS light up for a sec, the Cu port loses connectivity.
I tried to push reset then hold for at least 5mins after plugging it in, but netinstall just says "Waiting for RouterBoard".
I believe I understand how netinstall works and I tried almost everything from 2 different PCs, but nothing seems to work.
A real HW failure would be strange, as this device was switched off for most of the time since I purchased it 2 years ago.
Also it was mounted above my desk and it never really got hot. So no physical abuse.
Any ideas please?
Was it for my beautiful CRS305? Has someone seen a similar issue?
Edit: also tried replacing the PSU and tried main and backup bootloader (pressing reset before and after plugging in) > no luck yet