Mirip NTOP ya Pak ?
Sumber :
Welcome to Traffic Squeezer Project Home
Traffic Squeezer is an open-source project which does provides WAN Network Traffic Acceleration solution through a set of procedures on a Linux based network device released under GNU General Public License.
For more details about Traffic Squeezer Project, refer the Project Documentation and the README provided along with the source code.
The project is in its prototype development stage. So, please go through the project Road map. Volunteers who want to take part/contribute/sponsor this project are requested to express their interest in the project mailing list or in the discussion forum.
Traffic Squeezer - Introduction
To get connectivity between various branches of the organization, a corporate will need a leased line links to their terminating/edge gateways. The gateway devices connects to the service provider’s leased line circuits to get connected to their remote branch offices. Since the leased lines are very costly, corporates will get leased lines of some kbps to few Mbps speeds.
The data which is sent can be processed in this scenario and sent through the same less capacity leased line. Based on each specific deployment scenario the processing mechanism could be incorporated. The traffic acceleration can be achieved with packet/frame coalescing, compression, protocol specific optimization or a hybrid mechanism of combination of such techniques. To achieve traffic acceleration and a better link performance, couple of Traffic Squeezer boxes are deployed at each end of the corporate network termination as shown in the below picture:
Fig: Existing Deployment
Fig: Deployment with Traffic Squeezer Box
Fig: Deployment with Traffic Squeezer Box multiple sites
Fig: Deployment with Traffic Squeezer Box multi-ISP redundant/fault-tolerance and aggregated/load-balancing links
Please review nya buat yg sudah pernah coba
Trims
| m | a | m | a | n |
Mirip NTOP ya Pak ?
mantep juga tuh. apa bisa kayak packetter ya
buat monitoring juga bisa kayak mrtg !!!!![]()
Last edited by licio85; 01-12-2008 at 18:04.
boljug... nunggu review ah..
topologinya cuma di taruh di cpe?? hmm
@TS kalo dah pernah install kasih tutorial nnya dong. masalah nya di documentasinya lum ada cara install nya
berarti itu bisanya dipakai kalo peer nya atau node yang tersambung juga saling menggunakan paket squizer dong, klo buat kepentingan internet berarti gak bisa ya om, sananya kan blm tentu pake paket squizer?
There are currently 1 users browsing this thread. (0 members and 1 guests)